ডায়নামিক-বায়োসেন্সর-লোগো

Dynamic Biosensors helix cyto Normalization Solution

Dynamic-Biosensors-helix-cyto-Normalization-Solution-product

স্পেসিফিকেশন

  • পণ্যের নাম: heliX cyto Normalization Solution (Red Dye)
  • অর্ডার নম্বর: NOR-R2
  • For scIC measurements in the red channel
  • শুধুমাত্র গবেষণা ব্যবহারের জন্য
  • Limited shelf life – please check expiry date on label

মূল বৈশিষ্ট্য

  • হেলিএক্সাইটো চিপের স্পট 1 এবং স্পট 2-এ ফ্লুরোসেন্ট সংকেতগুলিকে স্বাভাবিক করার জন্য
  • Enables correct real-time referencing of the red fluorescent signals during scIC measurements
  • Compatible with all heliXcyto chips
  • The Normalization solution (red dye) contains a hydrophilic red dye with a single negative net charge.

পণ্য বিবরণ

  • অর্ডার নম্বর: NOR-R2

সারণী 1. বিষয়বস্তু এবং স্টোরেজ তথ্য

উপাদান ক্যাপ Concentr ation পরিমাণ স্টোরেজ
Normalization solution-R2 লাল 10 µM 6x 100 μL -20°C
  • শুধুমাত্র গবেষণা ব্যবহারের জন্য।
  • This product has a limited shelf life; please see the expiry date on the label.
  • To avoid many freeze-thaw cycles, please aliquot the solution.

প্রস্তুতি

  • Use this red dye normalization solution for scIC measurements in the red channel (analyte label-dependent).
  • Dilute the 10 µM normalization stock solution to a working concentration with running buffer.
  • The concentration of the normalization solution should approximately correspond to the fluorophore concentration in the highest analyte concentration to be measured. This can be calculated usingthe  following equation:

Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-1

  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-3 Concentration of the normalization solution in the desired color :
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-4লেবেলযুক্ত অ্যানালাইট দ্রবণে রঞ্জকের ঘনত্ব
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-5Highest concentration of the analyte that should be measured
  • Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-6Degree of labeling (ratio of dye to analyte)

পাতলা দ্রবণগুলি 2-8 ডিগ্রি সেলসিয়াসে 7 দিন পর্যন্ত সংরক্ষণ করা যেতে পারে।

আবেদন নোট
In the scIC measurement, the fluorescent signal of the normalization solution should be in a similar range to the highest signal coming from the bound analyte (raw data). The absolute fluorescent signal is dependent on normalization solution concentration and the excitation power applied in the measurement. The excitation power has to be selected based on the following parameters:

  • Fluorophore concentration inthe  analyte solution
    ফ্লুরোফোর ঘনত্ব পরিমাপে ব্যবহৃত বিশ্লেষকের ঘনত্বের পাশাপাশি বিশ্লেষকের লেবেলিংয়ের ডিগ্রির উপর নির্ভর করে। উচ্চ DOL এবং উচ্চ বিশ্লেষক ঘনত্বের জন্য, উত্তেজনা শক্তি কমানোর প্রয়োজন হতে পারে।
  • প্রত্যাশিত বাঁধাই সংকেত
    Highly expressed targets on a cell can bind more molecules of the labeled analyte. In case of highly overexpressed targets, a strong binding signal can be expected. To avoid the shutter closing, lowering the excitation power might be considered.
  • কৃপণ প্রকিতির
    বিভিন্ন ধরনের চিপের বিভিন্ন ফ্লুরোসেন্ট ব্যাকগ্রাউন্ড রয়েছে। ফাঁদ যত বড় হবে এবং চিপে যত বেশি ফাঁদ থাকবে, ব্যাকগ্রাউন্ড সিগন্যাল তত বেশি হবে। অতএব, L5 চিপগুলিতে M5 চিপগুলিতে প্রয়োগের চেয়ে কম উত্তেজনা শক্তির প্রয়োজন হতে পারে।

For a starting point of excitation power and normSolution on concentration to be used in an scIC experiment, please refer to Table 2.
Table 2. Relation of fluorophore concentration, normalization solution concentration, and excitation power suitable for an Dynamic-Biosensors-helix-cyto-Normalization-Solution-fig-2 M5 চিপ

অ্যানালাইট ডাই কনক। = বিশ্লেষণ conc x DOL উত্তেজনা শক্তি ঘনত্ব স্বাভাবিককরণ সমাধান পাতলা স্বাভাবিককরণ সমাধান
25 nM 0.5 25 nM 1:400
50 nM 0.3 50 nM 1:200
100 nM 0.2 100 nM 1:100
300 nM 0.1 300 nM 1:33
500 nM 0.08 500 nM 1:20
1 µM 0.05 1 µM 1:10
2.5 µM 0.02 2.5 µM 1:4

দ্রষ্টব্য: This table is for your guidance. However, the final signal recorded in the heliXcyto depends on many factors. Thus, some optimization will be required for each system.

যোগাযোগ

ডায়নামিক বায়োসেন্সর জিএমবিএইচ
Perchtinger Str. 8/10 81379 Munich, Germany

ব্রুকার সায়েন্টিফিক এলএলসি
৪০ ম্যানিং রোড, ম্যানিং পার্ক, বিলেরিকা, এমএ ০১৮২১ মার্কিন যুক্তরাষ্ট্র

www.dynamic-biosensors.com
যন্ত্র এবং চিপগুলি জার্মানিতে ইঞ্জিনিয়ার এবং তৈরি করা হয়। ©2025 ডায়নামিক বায়োসেন্সরস জিএমবিএইচ শুধুমাত্র গবেষণা ব্যবহারের জন্য। ক্লিনিকাল ডায়াগনস্টিক পদ্ধতিতে ব্যবহারের জন্য নয়।

FAQs

What is the shelf life of the heliX cyto Normalization Solution?

পণ্যের একটি সীমিত শেলফ জীবন আছে। নির্দিষ্ট তথ্যের জন্য লেবেলে মেয়াদ শেষ হওয়ার তারিখ চেক করুন।

How should I store the NOR-R2 v1.0 product?

The product should be stored according to the storage information provided in Table 1 of the user manual.

Can I use this product for clinical purposes?

No, this product is for research use only.

দলিল/সম্পদ

Dynamic Biosensors helix cyto Normalization Solution [পিডিএফ] ব্যবহারকারী ম্যানুয়াল
helix cyto Normalization Solution, helix cyto, Normalization Solution, Solution

তথ্যসূত্র

একটি মন্তব্য করুন

আপনার ইমেল ঠিকানা প্রকাশ করা হবে না. প্রয়োজনীয় ক্ষেত্রগুলি চিহ্নিত করা হয়েছে *